OST-042-01: The Dubai Deception

[oldeskewltoy]

from faceboo Wrote:There is no way that can only be -7CC dish. The actual dish looks deeper than the GZE and then those massive troughs on top of that? There is no way that piston has more compression than a gen 1 GZE.

I was warned about facebook ..... I had these built to my specifications. I told the JE engineer each time I had a change to VERIFY the volume was -7cc... but because I'm an anal retentive SOB... the piston's dish was measured.... AND verified @ Loynings.




This piston took multiple weeks to design. Its primary goal was to offer a "stock" replacement (8.9:1) 4AGZE piston with squish pads which the OEM 4AGZE slugs do not incorporate.... but with a bit more. This design can be manipulated easily to offer from 10:1 on down.



A few more details...







All loaded up and heading over to Loynings with the block, crank, rods, head, and OS valves....




more to come.....