nzae86's TRD ae86 N2 Race Car Project 2,

[Kid Karola]

Project D Wrote:I want the same carbon door cards

+1

Also if you can't get hold of AE86 winders in black SW11 MR2 ones are identical.

[einneb]

what a amazing build! i wish i had those skillz

[nzae86]

Hi , thanks for the help on finding black handles , I do have a couple of facelift black interiors in my pile of interior trim but need to sort the rather large pile to find them !!
I still need to make a cover for the fuel system and battery bracket then off to the track. My sign-writer fitted alot of clear stone chip protector to the guards yesterday to stop some of the stone damage from running soft slicks .
Cheers

[Project D]

Is it possible to know the flow rate of your injectors ?

[nzae86]

Project D Wrote:Is it possible to know the flow rate of your injectors ?

Hi there
The injectors are a Bosch 460cc , I haven't seen the tuning data yet but would imagine from initial set up that they are at about 75-% duty cycle ?.
Hope this is of some help

[Project D]

Yes actualy that exactly what I wanted to know
(I did some calculations and I found something around 400cc @ 3bars/43.5psi and 80% duty cycle)

[slacker.cam]

I have a quick question for you... Back on page 5 you have a pic of a pile of bolts and brackets you had stripped and electroplated. Where abouts did you get this done and what was the approximate cost? I have a similar pile that needs to get sorted out. Cheers.

[Super86]

Quote:I have a quick question for you... Back on page 5 you have a pic of a pile of bolts and brackets you had stripped and electroplated. Where abouts did you get this done and what was the approximate cost? I have a similar pile that needs to get sorted out. Cheers.

I also asked the same question! If you're in Auckland try Rigg Electroplating (http://www.riggelectroplating.co.nz/) on the Shore - they are doing all of the bolts and brackets from the car for $200...
Cheers

(Sorry to spam your thread!)

[timh]

I got a bunch of stuff done at Rigg also, for about 200 bucks.
They were pretty slack though, make sure you give them a deadline.

edit.
They did a good job though. I guess doing a heap of nuts and bolts and other small parts is not their favourite type of work.

[nzae86]

slacker.cam Wrote:I have a quick question for you... Back on page 5 you have a pic of a pile of bolts and brackets you had stripped and electroplated. Where abouts did you get this done and what was the approximate cost? I have a similar pile that needs to get sorted out. Cheers.

Hi there
I had my stuff done by Forlong and Maisey in Hamilton , sent all the bits in as they came off the car , everything came to about $120 . I have had some fittings done by Rigg (special coating) for work and did take a bit of time but good job done .