Project SE82 (3S-GE powered AE82)

[Pugho]

(I have removed the question in the first post. One of you moderators can remove your answers if you like.)

Allrightythen I guess you want to see some pics.
This is the poor excuse for an engine that was there before:


The front and rear tranny mounts bolts almost right up to the S-53 tranny.. The front one needed to be moved a little bit to the right for the engine to point straight. The left and right mount couldn't be used at all since they weren't only in the wrong places. They were also too narrow.
So I cut them off, along with the battery plate. The battery will be moved to the trunk anyway.

Testfitted the new engine:


The right engine mount. As you can see it wouldn't have fit at all.


Really dirty tranny.. This mount needed to be moved a little bit forwards.


Begun working on the left tranny mount. Cutting that 4mm steel plate with a 3mm cutting disc on the angle grinder is hard work:


Also removed the tank because it needs to be converted to EFI..


As you all can see, there is still A LOT to be done..
Not as fun to work on it now as it was in the summer though.. Had about 7 degrees C in the garage today..

So what do you think? Should I keep posting pics? (retorical question )