Won´t start

[jondee86]

If the car stopped and then you found the broken plug, it is likely that you lost the
rpm signal to the ECU. And the engine will not run without an rpm signal.

You need to make sure those wires from the didtributor to the ECU are connected to
the right place. Wiring diagram says G1(black) and Ne(white) and G-(red) but I can't
find any clarification on the dissy pigtail colours. So if you have a 24+4 tooth dissy...

G1 is the reluctor signal wire from the 4-tooth wheel
Ne is the rpm signal from the 24-tooth pickup
G- is the common ground wire from both pickups.

You will need to open up the dissy to see what colours come from where, and then
match them to the wires going to the ECU.

Cheers... jondee86