Engine wont start - cranks OK - NOW WITH VIDEO

[max_ae86]

jondee86 Wrote:What he ^^^ says After a few times cranking and not starting, the
plugs get wet, and won't fire no matter how much you try. If this is the
problem (easy to check by pulling the plugs) pop in a fresh dry set, and
often it will fire up straight away.

You can dry wet plugs out by holding them over a gas flame for a few
minutes. Clean off any carbon buildup with a wire brush at the same time.
Wire brushing is not recommended by the factory, but a clean, dry plug
is 100 times better than a wet carboned one !!

Cheers... jondee86

I had the same issue with spark plugs. After good cleaning it started with no probs. Try to clean plugs!