Spindle dimensions, backing plate bolt pattern

[Rascal21]

Nice! Any measurements that line up here would be extremely helpful for my plan to install the front coilovers this car deserves.

I just got back from an email chat with T3, and according to a drawing that they sent me (Which I dare not post here), which showed bolt spacing/pcd of RA40, TA22 and TE72 hub carriers, my measurements are the most consistent with TE72 hub carriers:

And remember my measurements are according to a well-used caliper:
My hub carriers have 64,75mm square PCD for caliper brackets.
TE72 hub carriers have 64mm square PCD for caliper brackets.

My spindle diameter are 17,5mm outter, 30mm center, 40,9mm inner.
TE72 spindle dimensions are 17,5mm outter, 29mm center and 41mm inner.

This is too good to be true? I finally know what hub-carrier I have?