Surreptitious.....

[oldeskewltoy]

Thanks... the Nardi wheel will just have to do :wink:


Notice... if you will, that in the photo showing all the interior bits.... the large "C" pillar trim is missing, well, I finally removed those, and sent them over to Color Glo... I HOPE to have a reconditioned photo of all the trim within a week or two.....





For over a year now I've been trying to find an extra "GT" emblem. There is the grill mounted one



and I've been trying to find something close so that I can add it to the back of the car....



From many searches there aren't many "GT" emblems, especially in red. What I usually end up finding are either Skyline GT-R emblems, or old Mustang type "GT" emblems.... or more recently the 370 GT emblems, none of them are even close enough to consider.

Well, while doing some chrismas shopping I come across a GT emblem from an Elantra - it cost all of $14.00 shipped :eek:



Its close... a bit of a lean, and the G and T are attached.


Part of that I can "fix"




Here is the "new" emblem and the original



It's not perfect, but mounted in the back(away from the one up front) few if any will actually see the difference........


So now to decide where on the back of the car to fit it. The small ledge directly under the taillamps are just tall enough to fit the emblem without overhang, another thought was to mount it to the spoiler face - off to one side or the other (it doesn't fit over the lock cylinder)

Anyone have any ideas? My initial idea was on the spoiler face directly over the right rear back-up lens... but I'm open to suggestions
.
.
.
.
.
.
.
.
.


here are some of the ideas.... (thanks to apex86 from C4AG)



I'm not sure it makes sense... but over the back-up light on the right kinda balances(????) the exhaust pipe under the back-up light on the left??? Or am I just enjoying the medication too much :roll:

Quote:I'm still waiting on the final lower control arms.... (ball joints do next week)

they'll get powder coated next week, and then well install AJPS sealed ball joints