Surreptitious.....

[oldeskewltoy]

Well, with temps actually ideal, Mark made it over in his new pocket ride and just about finished the wiring!!!! There are a few pieces I still need to acquire to actually make it possible to finish(TPS clip and wires, alt, starter, 10' of 4 gauge welding wire, and some other bits)

Mark has been camera shy... but I did promise a photo



That's Mark saying, "hi" The other reason for this photo is showing the management system wiring harness, and components, PRE made for this job by Marshall @ Jackson Autosport. Mark was VERY happy with this part of the job, it was a pleasant stroll compared to the chassis job. My investment in a premium wiring package was well worth it considering 95% of the management system is now fully wired in - in one session!!



As the photos show... some changes are taking place - (Aaron, I'm SOOOO glad we didn't weld that coil plate on to the firewall!!!)



Before today - the location to mount the coils...as of now, it turns out it is required as the pass through for the wiring harness plugs! Mark tells me a Supra/Cressy firewall grommet should work here.... The coils will be "relocated" to the frame mount, the ignition wires will be routed through the gap in the intake manifold between cyl 2 & 3

Note yellow zip tie... that plug is for the wideband.






There are a few more "discoveries" about my management system I had forgotten
fuel pressure monitoring, and oil pressure monitoring...besides oil temp. Both pressure sensors need to find a place to be mounted, I believe I have both of these places figured out.

Oh, again, sorry for the crappy photos... but most are clear enough........


note the fuel rail in the photo below... well, no 5th injector is need(small banjo bolt behind big one), SOOOO, I'll be having the fuel rail's 5th injector fitting re-sized to accept a 1/8NPT fitting(fitting on end of pressure sensor[s])


That solves the location for the fuel pressure monitor, but now what to do about oil pressure......




The photo above shows many new things... but for purposes of the oil pressure monititor... I have to check, but I see no better location to fit the oil pressure monitor but at the treaded plug on the oil pump! I'll have to find an adapter to go from the oil pump plug to 1/8 NPT, but there should be something available.

So, with my two new pressure monitor sensor locations solved, what other goodies do we see in the above photo... crank angle sensor fitted to crank angle sensor mount, and the "new" cam angle sensor fitted.


With the engine compartment wired, work proceeds inside the car.... as the system finds a home...



No A/C = no A/C box... allows mounting of the ECU just behind the duct work, down towards the floor. Note the small square plastic box on the end of the wire... hanging in front of MORE WOOD... well that small square is the USB connetor. That will be mounted in the glove box and is my ECU's portal to the world




As Mark was fitting the system, we talked a bit.... the FJO system will be leaving NOTHING on the table, and should make the Loynings engine perform as well as it was designed too


Things are now TRULY getting close! The parts list isn't that large... a few odd ball parts needed to get it fired: rwd tranny/block steel plate, ae92 GTS clutch kit(both needed to install trans), coolant gauge sender, adapter for pressure switch, and others as noted above....