Surreptitious.....

[oldeskewltoy]

Now... what the "F" am I doing with a cutting board????

Well, can you think of a better material for electrical circuit mounting??

It is non conductive, is fully shapeable, drill able, it holds screws firmly, and is firm and light and strong, empervious to most heat, and moisture.........



Here is the piece we need, shaped and drilled to fit a small alcove where the original fuse box resided. It not holds the 4 relay panel, but has room for as many as 6 more relays...





For those who have not viewed a car from this particular angle.... This photo was taken from the driverside edge of the radio enclosure, upper right is the upper clutch pedal arm, center left is a ziptie that is holding the lower edge of the dash to the body tabs. That photo adds perspective... the next shows just how much room there is......


All relatively easy to read and easy to access. Read? Yes read... the white panel should help direct light to this surface to aid in viewing during diagnosis, or for repair in the future.


So... Sushi was never the plan... just some "out of the box" thinking to engineer a solution to a problem.


More to come....... maybe sooner, rather than later..........