hachiroll`s rust&lowcompressionrolla project

[hachiroll]

fax0815 Wrote:Sounds like a sh** engine shop!
Noone never ever whould bore without measuring the pistons first!
How is he going to adjust the clearance without the piston?!?

It even matters where you meassure and what material was used for the piston. Hence why proper piston manufactures tell you the clearance it needs to be bored to, they are sometimes different from the OEM clearance, cause of material and geometry changes.

I´d buy 82,00mm and move to a proper shop!

Did he measure the crankshaft with a 0,05mm caliper? F*** me...

Thanks very much for this advice. The guy seemed a bit retarded
when he wrote instead of toyota corolla toyta corda, but I didnt want to judge him, I thought he has some writing defect . But now I know he is a retard. Lol. Tomorow I will take the block and probably inspect the damage that he has done to the engine block. But they seemed to have plenty of machines and there were also some customers...