A/C in AE86

Threaded Mode | Linear Mode

A/C in AE86

12-31-2020, 01:02 PM

Post: #26

chenfon Offline

Junior Member

Posts: 29
Joined: May 2011
Reputation: 0

RE: A/C in AE86

Guys, like to get advise on how many Psi / Bar that the R12 glass should refill back into AE86 aircon system. I just done replaced my compressor (10P13C-12) shaft seal due to leakage, and now wanna install & refill gas btu not sure how many pressure should fill in.
Base on the manual page AC-4 low pressure at 21-28psi; high pressure at 206-213psi @2000rpm. but page AC-14 mention low pressure not over 60psi until sight glass free of any bubbles.
so wonder which will be the correct pressure i look for. please do advise. tqvm

« Next Oldest | Next Newest »

Messages In This Thread

A/C in AE86 - Uzelac - 11-05-2008, 02:29 AM

RE: A/C in AE86 - chenfon - 12-31-2020 01:02 PM

A/C in AE86 - Mylesmck - 01-02-2021, 03:52 PM

RE: A/C in AE86 - decryphe - 01-08-2021, 08:02 PM

[] - banpei - 11-05-2008, 11:49 AM

[] - Rosedrift - 11-05-2008, 04:20 PM

[] - banpei - 11-05-2008, 06:27 PM

[] - parrot - 11-06-2008, 05:15 AM

[] - banpei - 11-06-2008, 10:46 PM

[] - parrot - 11-07-2008, 12:09 AM

[] - Uzelac - 11-07-2008, 12:31 AM

[] - parrot - 11-07-2008, 12:44 AM

[] - wormwam - 11-27-2008, 08:16 PM

[] - tolisspi - 11-27-2008, 08:27 PM

[] - banpei - 11-28-2008, 12:01 AM

[] - Uzelac - 11-28-2008, 12:33 AM

[] - Red - 12-20-2008, 06:56 AM

[] - Uzelac - 12-20-2008, 05:39 PM

[] - Red - 12-20-2008, 08:46 PM

[] - Uzelac - 12-21-2008, 02:50 AM

[] - Red - 12-21-2008, 07:40 AM

[] - Allexz - 12-21-2008, 11:02 AM

[] - Uzelac - 12-21-2008, 04:17 PM

[] - Uzelac - 12-21-2008, 04:24 PM

[] - Red - 12-21-2008, 07:33 PM

[] - Eircamae86 - 12-24-2008, 06:35 PM

[] - jondee86 - 12-25-2008, 02:26 AM

[] - Eircamae86 - 12-25-2008, 06:03 AM

User(s) browsing this thread: 1 Guest(s)