4age small port engine build

[sketchy]

Starting a thread on my 4age engine build as a result of the guidance on my <a href="http://www.aeu86.org/viewtopic/bigport-to-smallport-install/t/12923/start=0/postdays=0/postorder=asc/highlight=">bigport to small port install</a> topic.

The aim is to build up a late spec 16v engine but using early internals.

Late hardware
No T-VIS / small port head and fuel rail
7 rib block with oil squirters.
Matching (standard) 10.3 cr pistons.

Early hardware
Worked early con rods (to match 20mm pin dia on late piston)
Crank (matching 40mm big end dia)
Stock 240° cams
Injectors

Will post more on this shortly, but for the time being i have taken some pictures of the head i have just bought:

<a href="http://www.flickr.com/photos/83843624@N05/sets/72157633178189862/">4age small port head pics</a>
You may be able to see one or two areas i am a little concerned with.

It was purchased as a reconditioned item and 'untested'. From my untrained eye there is no terminal damage and it is not warped.

Welcome your comments all!