Velocity Stacks - Which, Where, How much?

[apardal]

I just bought an ITB setup for my engine and I'm looking for velocity stacks for it. Besides T3, which stacks and where can I buy for silvertop?

Are there any carb stacks that can bolt on this setup? They come a lot cheaper than T3, for example, and look the same. I'm just not sure about the size and bolt pattern.

Best regards

[Erik_dk]

I will follow this. i have also silver itb´s and need the stacks:-)

[Jan Pedersen]

I'll go for these:


They are €200 for the set...

[Akis308]

check here guys.
You need 48 mm diam...
http://www.jenvey.co.uk/

[apardal]

Jan, you just missed the where question!!

By the way, what's the inside diameter of the ST ITB's? I heard it was 43mm... and the BT 45mm...

Not sure though!

[Akis308]

48 both.
Inside Diameter,yes.
The diference is on the holes.
for S/T you can use from Peugeot, the holes are the same.
You only have to slighty modify the lip (top end) of the velocity stack, because you are going to have a small contact there....

[Jan Pedersen]

I've heard that it was 45 and 48 mm

Apardal, well maybe i didn't quite answer you question but unless you are interested in these stacks and are willing to pay €200 for them there isn't much point in telling you where to get them

I can order them here in Denmark if you want them... Here is a link: http://www.sitecenter.dk/sjctoyota/hjemmeside/

[apardal]

Measured them yesterday and the biggest inner diameter at the top is around 46.5mm.

Best regards

[isac]

apardal Wrote:Measured them yesterday and the biggest inner diameter at the top is around 46.5mm.

Best regards

My measure with Vernier caliper is 47mm