|
mixing blocks and heads
|
|
09-24-2006, 10:47 AM
Post: #11
|
|||
|
|||
|
mixing blocks and heads
Mux... I am asking about 4A-FE not 7A-FE.
...you been on medication again? ;-) ![[Image: AEU86 AE86 - mixing blocks and heads]](http://www.ae86.pl/ae86banner.jpg "AEU86 AE86 - mixing blocks and heads") Always remember: Rev it till it blows, then back off a bit... Zenkis - Orange, Red/Black, Silver/Black, Maroon/Blue Koukis - Red, Silver/Gray, |
|||
|
|
09-24-2006, 12:09 PM
Post: #12
|
|||
|
|||
|
mixing blocks and heads
There is some information
4A-FE and 4A-GE blocks are same. All crankshaft is not same, all 4A-FE have 48mm/40mm crank and newer 4A-GE have 48mm/42mm crank. There is at least 2 type of conrods,with 18mm or 20mm upper hole. Flywheel have 6 or 8 bolts Anyway, you can use 4A-FE block and put 4A-GE stuff in it. |
|||
|
|
|
09-24-2006, 12:34 PM
Post: #13
|
|||
|
|||
|
mixing blocks and heads
daytone, oops, sorry, thinking to much about 7's hehehe
 and yes I am on medicene atm
Greetz, Bastiaan "mux213" Olij Moved down under, no more hachi 
|
|||
|
|
|
09-24-2006, 04:09 PM
Post: #14
|
|||
|
|||
|
mixing blocks and heads
S.K. Great!, exactly what I wanted to know.
Mux hehehe, I wrote the message at night, and then when I saw your reply, I actually double checked on what I wrote, because I thought I was tripping ;-)
Always remember: Rev it till it blows, then back off a bit... Zenkis - Orange, Red/Black, Silver/Black, Maroon/Blue Koukis - Red, Silver/Gray, |
|||
|
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)