HELP!!! hard time starting
|
03-29-2012, 08:59 PM
Post: #29
|
|||
|
|||
Check/refresh the grounding of the igniter to the chassis. It grounds through
the outer casing, so it needs to be bolted down with a good contact to the chassis. Check the wires that conect to the distributor at the point where they pass from outside to inside. Due to constant flexing the wires can break or rub through the insulation. Look inside and outside the distributor for any signs of "soft" wires (broken inside the insulation), exposed wires, bad connections. Check for damage inside the distributor cap. Clean all the metal surfaces and make sure the outer edge of the rotor is square and not covered in oxidation. Make sure the carbon button is still there. Cheers... jondee86 |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HELP!!! hard time starting - drift - 03-17-2012, 04:33 AM
[] - jondee86 - 03-29-2012 08:59 PM
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
lntermittent starting | totta Crolla | 6 | 3,041 |
08-31-2021 06:21 PM Last Post: totta Crolla |
|
Starting problems 4-AGE kouki | Hanzo | 3 | 2,157 |
08-31-2021 06:20 PM Last Post: totta Crolla |
|
Hard start issue | kazi | 5 | 6,112 |
05-23-2017 11:31 PM Last Post: kazi |
|
JDM trueno not starting. need help! | kazi | 8 | 7,855 |
03-12-2017 05:05 PM Last Post: kazi |
|
US-spec vacuum hard lines | LordTD | 2 | 4,612 |
04-27-2015 07:18 PM Last Post: Project D |
User(s) browsing this thread: 1 Guest(s)