ring&pinion set info

[filh]

Ivan , that's just what it was done before on my former R&P , using the old depth pinion shim and that's What I'll do .
Using the manual , that's a good start , but I had to do special tools by myself . I ground the bearing bore (an old bearing of course) to make it slip easily .I don't know if you've ever tried to remove the inner bearing ,not really a pleasure party !
I also made a tool to figure the ring center , where you measure the pinion depth .
Hope I can fix that soon , but it's rally time this week-end , and it's painful to drive with 15" rims and stock R&P .
And It's now very difficult to find competitive 13" tyres .
Phil