MAP Harness help

[jondee86]

No diagram, but if you were staring into the end of the half of the plug
that is connected to the engine side of the loom (connecter clip to the
left and locating lugs top and btm on the right) you would see this :

[1] [2] [3]
[4] [5] [6]
[7] [8] [9]

These numbers represent the three rows of three pins inside, which are :

1. Backup (reversing) light switch
2. Backup (reversing) light switch
3. Spare pin
4. Igniter power supply (black/orange wire)
5. Power supply to injectors (yellow wire)
6. Starter/cold start injector
7. Water temp gauge (on instrument panel)
8. Oil pressure gauge (on instrument panel)
9. Tacho (rev meter) signal

Hope your plug looks like this

Cheers... jondee86