Banpei's two door panda Trueno from Japan

[Koen]

I'm wondering if the sizes they listed in your auction actually match with your wheels because mine fit a lot less wide although they are supposed to give more poke.

Did you fully load the suspension? I see you put blocks under the wheels so I suppose you did. Otherwise they will camber in a bit when you put the car on it's wheels.


This is silver formula mesh on a silver panda car. Size is 14x7 ET-3


This is the front fitment with 185/60R14 tires. It's supposed to poke 3mm more than your wheels if I compare the specs (you have 6mm more due to the 1/2" extra width, but 9 mm less due to offset so the difference should be 3mm)


Also picked up a set of Watanabe's in 14x7.5 ET-10 (according to seller, did check it roughly and it seems to be correct)


This is the front fitment with 185/60R14 tires. It's supposed to poke 16mm more than your wheels if I compare the specs.

The car only has lowering springs (40mm). The Watanabe's are a bit too aggressive without more suspension and fender mods I guess, but with 16mm less it might just clear.