Banpei's two door panda Trueno from Japan

[banpei]

I have to see if the fronts aren't too wide. Some time ago, I took some not-so-scientific measurements of my current wheels, and this is the gap I have to bridge:

32mm at the front and 41mm at the rear

My current wheels are 6.5 +25 (front) and 6.5 +15 (rear). If I calculate the change to the 7.5 +6, it would mean the new wheels would extend 28mm outward at the rear and 38mm at the front. As my measurements were haphazardly done, it could be the case didn't centre the plastic box properly, and it could change a few millimetres in the end. So, I have to mount the SSR wheel and see if it pokes out too far or not.