Blaze's AE86

[Blaze0010]

It's been a while since the last update, but well, i might say that i'm almost done with the restoration!
Since the last post i was able to complete the seats (and the interior) and to finish all works on the body.
Mainly:
- installed seat cover
- install all the lights (ended up using clear bumper light lenses from a Camry)
- installed mouldings all around
- bit of engine bay wiring clean up
- finished body work on door and rear hatch, and installed everything
Doesn't seems like to much but everyone of these task has a LOT of steps and thing associated that are very time consuming ahah
Here some pic of the disassembled seats for decryphe i'll post the other photos in another post

---

Pics of the seats and lights

---

Final pic with the car finally out in good company








Now there is the hard part, getting it roadworthy.
But before that i still have a couple of issue to fix, the most important one is the handbrake that currently is not working at all.
I have, new disc, new pad, new rear caliper, all 3 new cables, but still, even following the guide i've found on the forum, the handbrake does not hold and i can simply push the car while engaged.
The weird thing is that even with 0 slack between the pad and the disk, and with the adjusting nut at the bottom, it still goes up to like 13 click, so reach the 6-9 click range seems impossibile. I've even tried with a Celica cable (2cm shorter), and i can reach that range but still doesn't hold.
The only thing i can think of now is that the disk and pad need to be seated, so i should drive a bit and engage the brake to remove the superficial protection.
Other than that, the rear brake work fine.