valve tick on cylender two intake

[Bean]

No even with 0 clearance it remains a free runner. But 0 clearance will wear down your cams

if I skimm over your numbers most are out of spec - not just these two. .0X is out of spec as is .3X etc...
double and tripple check your measurments and write everything down, then remove the shims (if you don't have the means to remove them with the cams in place remove the cams) - when removing the sims keep them in order! (ice cube forms or egg carton work well and cheap). measure/check the size of all the shims and write does down too (always double or triple measure).

Then you'll have to do some math and/or use an excel sheet - you might get lucky and they are simply mixed up completely or you'll need to get a few - some you'll be able to use in different spots to get the right clearance - aim to get them as even as possible.