ae86 13B-REW Odessa
12-20-2010, 11:25 PM
Post: #20
 
In this case gravity threw for manufacturing crossmember has no value. A thickness 2мм... And the weight not on differs from стандартоной crossmember many. Crossmember it is executed in the form of a box - has appreciable improvements before a stamped product..... Rigidity in tens times above.... Moreover. At the equipment wankel the drive I have already won in weight several times... Even without plastic products)))) and rigidity of a design at высокооборотистом and the powerful drive for me is much more important)))) especially if turbine Garret GT42)))) is established) all is counted also all considered at configuration of the given product.....
Find all posts by this user


Messages In This Thread
ae86 13B-REW Odessa - worm72 - 12-17-2010, 11:20 PM
[] - worm72 - 12-17-2010, 11:43 PM
[] - nmwisima - 12-18-2010, 01:16 PM
[] - [Walaki]D`Lair - 12-18-2010, 02:43 PM
[] - worm72 - 12-18-2010, 06:00 PM
[] - doggy - 12-18-2010, 06:24 PM
[] - robokill - 12-18-2010, 06:25 PM
[] - Eric - 12-18-2010, 06:26 PM
[] - worm72 - 12-18-2010, 06:33 PM
[] - worm72 - 12-18-2010, 06:35 PM
[] - Eric - 12-18-2010, 06:37 PM
[] - worm72 - 12-18-2010, 06:46 PM
[] - worm72 - 12-18-2010, 06:51 PM
[] - [Walaki]D`Lair - 12-18-2010, 06:55 PM
[] - Eric - 12-18-2010, 07:20 PM
[] - MatthewG - 12-18-2010, 10:49 PM
[] - Lajoosh - 12-19-2010, 12:32 PM
[] - [Walaki]D`Lair - 12-20-2010, 01:03 AM
[] - DRFT - 12-20-2010, 03:34 PM
[] - worm72 - 12-20-2010 11:25 PM
[] - worm72 - 12-20-2010, 11:27 PM
[] - DRFT - 12-21-2010, 11:01 AM
[] - nmwisima - 12-21-2010, 11:41 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication