OBX Exhaust Systems

[Ivan141]

You forgot to mention that it nearly touches the chassis floor under your feet. This wouldnt be important to mention if you werent using cusco lower engine and gearbox mounts that bring the engine down a notch.
There's a good chance that it simply would foul the chassis otherwise.

Also you have shortened the rear silencer mount and it is still quite low to the ground (the bend before it goes up over the diff). And you had to weld a hole shut that was left open on the flange of the downpipe.

Just a warning so people dont go thinking it is a good fit, because it just isnt.
For the money it is not strange that you have to do some modding to fit it, as robo demonstrated it can be pulled off with some minor welding.