Header + exhaust for Beams setup

[KD2229]

Any advise?

Looking for a 4-2-1 + mid pipe + exhaust to fit to the beams.
I believe there should be no off the shelf item and need to go for custom.

But at least I need the advise for the 4-2-1 header and I think I can manage to get the mid pipe and exhaust custom made.

Please share your idea.

Thanks,
Yung

[oldeskewltoy]

How large an exhaust diameter do you need? I assume this is for an AE86?? I know of 2 full size muffler exhausts(over axle) that use 60mm diameter piping. One is Kakimoto R - http://www.kakimotoracing.co.jp/image_ts332.html Cost: about 75000 yen





The other would be Brave - http://www5f.biglobe.ne.jp/~brave-nh/pro...-list.html - look for BRMT028 Cost: about 39800 yen

[KD2229]

It is for my 86 and currently installing a Beams on it, so need a different exhaust.

I would like to go for a standard dia now, not sure if the standard one for Beams is 60mm?

I have the stock header now but apparently it is too low and nearily touch the ground.
Wondering should I go for a after makert 4-2-1 header or just modify the stock one to fit a custom make down pipe then so on.

[KD2229]

So, does anyone know if the stock exhaust for beam is 60mm dia?

Thanks in advance.

[assassin10000]

According to this, it appears to be 60mm.

http://trdparts.jp/english/parts_engine-3s-ge.html


Andrew

[KD2229]

Thanks Andrew!

I think I will go for a 86 - 60mm mid to exhaust and modify the header to fit it.

I believe you do the same in your car, right?

Cheers!

[oldeskewltoy]

KD2229 Wrote:Thanks Andrew!

I think I will go for a 86 - 60mm mid to exhaust and modify the header to fit it.

I believe you do the same in your car, right?

Cheers!

I'm running the Brave in my car... :wink: http://s79.photobucket.com/albums/j143/o...peview.mp4

[KD2229]

Dan,

You've got PM.