|
16v to 20v throttle body's TPS
|
|
10-21-2009, 04:38 AM
Post: #4
|
|||
|
|||
|
Jondee my recollection is that it's the brown and yellow wires that need to be swapped.
However, I would just use your multimeter to test the resistance across the pins. When you open the trottles the VCC-IDL will open resistance and continue to climb, VCC-sensor (VTA?) will vary dependant on position of the throttles. I had to do this recently as I was feeding the IDL wire to my ecu rather than the propoer sensor. My hazy memory says blue is VTA, but double check that! Look here: http://www.autoshop101.com Chris |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
16v to 20v throttle body's TPS - lolali - 10-20-2009, 04:04 AM
[] - Chrisso - 10-21-2009 04:38 AM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Looking for jdm spec body repair manual | AE111 | 0 | 823 |
10-08-2025 10:33 AM Last Post: AE111 |
|
| TPS and stop screw set up | kazi | 7 | 11,787 |
04-23-2017 09:40 PM Last Post: kazi |
|
| How to install 20V ITB on 16V head | Mr.komp | 7 | 14,929 |
12-28-2015 05:35 PM Last Post: pack |
|
| 16V ECU pinout on 20v swap | pack | 2 | 7,449 |
06-12-2015 01:22 AM Last Post: pack |
|
| 20v block with 16v head and internals possible? | ditn | 3 | 8,862 |
08-12-2014 09:19 PM Last Post: ditn |
|
User(s) browsing this thread: 1 Guest(s)