ford type 9 gearbox with 4age engine
|
12-08-2014, 11:52 PM
Post: #2
|
|||
|
|||
RE: ford type 9 gearbox with 4age engine
Here is a bellhousing:
http://www.motorsport-tools.com/catalogs...lt/?q=4age Ideally you want to buy an original RM sport one as it will fit first time without issue. You use a slightly bored out Toyota release bearing carrier with the Toyota bearing. Use your Toyota fork and slave cylinder. If you are using a 200mm flywheel then you can use your Toyota clutch cover with an MGB clutch plate. For competition use Helix make a complete clutch in either 200mm or 215mm to suit. http://www.helix-autosport.com/products/...es/toyota/ A four speed Ford gearbox will line up nicely with the gear lever hole in an AE86 but the 5 speed type 9 gear lever is further back so some modification of the hole will be required. Gearbox mount can be fabricated from the AE86 one. AE86 propshaft can be modded to suit the Ford output shaft, I had this done but eventually went for a bespoke single piece propshaft. If your intention is to run a Quaife (or similar) close ratio 'box you will definately need a final drive of 5.1-1 or lower An analogue brain in a digital World |
|||
« Next Oldest | Next Newest »
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
Ford gearbox | totta Crolla | 0 | 1,115 |
02-15-2022 05:21 PM Last Post: totta Crolla |
|
4ac gearbox on 4age | hachirokkos | 2 | 5,321 |
05-24-2016 10:16 PM Last Post: banpei |
|
toyota a series engine....can a fwd corolla engine be used | 210 datsun guy | 5 | 7,675 |
10-30-2013 11:18 PM Last Post: banpei |
|
7AGE to W58, cluth type? | slowboy2 | 3 | 5,128 |
05-25-2013 01:37 PM Last Post: slowboy2 |
|
Type of carbs to suit 4ag | kpretro84 | 23 | 21,456 |
02-09-2013 02:29 AM Last Post: bakonick |
User(s) browsing this thread: 1 Guest(s)