My Tuned AE86 project

[thanhngo]

Boring Chassis Prep. Usual stuff of removing rust and deadener (this car has extra deadener) so nothing that interesting on that side.

Got a new toy however:
P-craft 4-2-1 N2 extractors from Japan.
Primary: 36mm ID, ~750mm length
Second: haven't measured
Exit: 2.5inch.

Brought this based on the tuned length was what I was after. Might be tempted to install this on the 16v to compare it against my current 4-1 RSR.



Oh and heres the other 'side project' (yeah I have a few of them...probably explains why im taking so long).


If I can't have a f20c, at least I can pretend I have one.

First step was to organise the 'electrical' wiring.
I went down to the salvage yard to find the connectors for these (ebay wants $150) or so but I found them on combination Honda Prelude (80s), Mitsibushi magna (90s) and Mazda (90s). So I started pulling out wires that weren't needed. Here is my SST of choice, a modified fruit pick.


Connect A: Just gotta wedge the top down and the wire will come out.


Connect B: Left sides and retainer, then pick the clip out.


Connect C:


Connect D:


Lots of excess wiring removed and quite boring but satisifying at the end. Will post wiring diagrams later.