|
Doubt about TRD springs height
|
|
08-21-2008, 07:44 PM
Post: #9
|
|||
|
|||
|
I had to cut half a coil to get the rear to set down level with the front. Running TRD front and rear with short stroke setup. Kinda wish I had just found a spring that sits the car lower than a trd rather than cut it. (they don't sit to good on the spring seat when you start cutting them)
|
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Doubt about TRD springs height - Rasteirinho - 08-20-2008, 12:46 PM
[] - Jan Pedersen - 08-20-2008, 01:39 PM
[] - Bubble_Drift - 08-21-2008, 12:48 PM
[] - hachirokuGTV - 08-21-2008 07:44 PM
[] - Bubble_Drift - 08-21-2008, 08:02 PM
[] - hachirokuGTV - 08-22-2008, 11:27 PM
[] - assassin10000 - 09-03-2008, 05:20 AM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| HKS valve springs | totta Crolla | 3 | 3,798 |
05-25-2022 10:24 PM Last Post: oldeskewltoy |
|
| Springs from other vehicles?? | FanIsHere | 16 | 18,366 |
05-17-2016 09:12 AM Last Post: FanIsHere |
|
| 3rd door support gas springs (stay) - worn out | max_ae86 | 5 | 7,612 |
09-01-2013 03:20 PM Last Post: Jezza_hr |
|
| Gear end , drive pinion height | filh | 5 | 13,286 |
06-27-2013 12:29 AM Last Post: filh |
|
| Kaaz width doubt, OEM is out of car | T_AE86 | 3 | 6,337 |
04-13-2013 12:05 AM Last Post: T_AE86 |
|
User(s) browsing this thread: 1 Guest(s)