Mikzu's 4A-GZE project

[Mikzu IV]

4agze Wrote:

Mikzu IV Wrote:Nono. it's a real gze from ae101, and I payed around 1200e for it.
The ignition coils are standard DLI, gze coils.
for the mounting you just take the old mounts from a rwd setup 4a and bolt them in the gze, you need to cut a little the s/c bracket, also the standard alternator bracket hits the rollbar, so you need to buy a gze mr2 aw11 one or do it by your self,


holy crap I really start to believe that Ive got the uglyest engine out there,
so many comments, and not only from here

its ok its just i haven't seen a valve color thats pink and i dont know if Luxemburg swings that way if you know what i mean? :wink:
so whats your plan on the intercooler?

LoL. I think I'm going for a small fmic, later. but now just with nothing not even the original cause it's damaged

Rick Wrote:You will find the the sensor block at the back of the head will be very close to the firewall. If thats the final position for the coil packs you could replace the sensor block with one from an AE86 or AE82 one which is alot slimmer.

What gearbox are you going to be using?

thanks for the advice, I was wondering if it's going to hit the firewall,
I hope my ae86 sensor block had 2 sensor places...
the gearbox will remain t50, but if it breaks I will go for the w55.


thanks petzk, you did it, but it's not really that red