Error code 8, advice??

[jondee86]

Nah... you have good results for the tests you have done. If you refer
to the top band on the page, you will see that No Voltage in the third test
is the Trouble condition, and that the STD Voltage is 2.0-2.8.

The tests on that page are checking the ECU power supply and ground
in case there is no voltage across THA and E2.

Fault code 8 indicates Open or Short Circuit in the air intake temp
sensor circuitry. First reset the ECU (disconnect battery and then put
your foot on the brake pedal). If the fault comes back, it might be a good
time to check that all your sensor plugs and wires are in good nick. A
bad/loose connector or wire rubbing on a sharp edge, might be causing
an intermittent fault.

Cheers... jondee86