"Check engine" light kicking in at 4-5k rpm
05-20-2008, 09:34 AM
Post: #5
 
Jezza_hr Wrote:Right, the diagnostics are giving me an error 6, which means there is no ground heading back to the ECU,...

For an AE86 error code 6 is:

6 RPM signal. No Ne, G signal (engine revolution sensor) signal to ECU within several seconds after engine is cranked. No Ne, G signal (engine revolution sensor) signal to ECU within several seconds after engine reaches 1,000rpm. Distributor circuit.
Distributor.
Starter signal circuit.
ECU.


This would stop your car from starting or running.
ECU thinks if the engine isnt spinning over, dont send fuel or spark.


Messages In This Thread
[] - Jezza_hr - 05-18-2008, 04:52 PM
[] - projectrollas - 05-20-2008, 05:01 AM
[] - Jezza_hr - 05-20-2008, 08:30 AM
[] - irishtwincam - 05-20-2008 09:34 AM
[] - Jezza_hr - 05-20-2008, 10:16 AM

Possibly Related Threads...
Thread Author Replies Views Last Post
  No idle below 2000 rpm rich running Steller Engineering 3 2,996 11-30-2022 02:45 PM
Last Post: RolanTHUNDER
  Bad vibrations /resonance starts at 5000 rpm izanagi 7 10,477 07-23-2015 05:02 PM
Last Post: Bean
  Engine Check Light at High RPM Super86 8 10,932 11-03-2014 11:03 AM
Last Post: Super86
  toyota a series engine....can a fwd corolla engine be used 210 datsun guy 5 9,965 10-30-2013 11:18 PM
Last Post: banpei
  engine start up and retractor light kawo 12 21,346 10-13-2013 02:23 PM
Last Post: pack

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication