|
My Tuned AE86 project
|
|
10-22-2007, 09:58 AM
Post: #7
|
|||
|
|||
|
There's been 2 people I read of who have successfully installed a AZ6 so I'm not breaking new ground...Just documenting the pain
 Dan's kit looks like a nice option - I'll tackle the "mating" problem bit later when I do more proper measurements.Visited my local wrecking yard for my daily exercise today... measured the Diameter of the output shaft where the Worm drive is suppose to be in the S15 box and its ~27mm. So im looking at finding a worm drive that can fit this. I measured a W5* auto box and it was ~29mm so thats bit too big. I assume the T50 is ~25mm based on the output spline. I've ordered a S14 worm drive (wild guess because the boxes look very similar) so I will have that tommrow to test - and hopefully fit. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
My Tuned AE86 project - thanhngo - 10-21-2007, 03:33 PM
my new gearbox - thanhngo - 10-21-2007, 03:44 PM
gearbox problem#2. - thanhngo - 10-21-2007, 03:54 PM
[] - Jan Pedersen - 10-21-2007, 05:36 PM
[] - thanhngo - 10-22-2007 09:58 AM
speedo drive for an s15 box - thanhngo - 11-29-2007, 01:33 PM
Fuel level sensor - thanhngo - 10-01-2008, 04:46 AM
|
User(s) browsing this thread: 1 Guest(s)