Crankshaft Bearings

[apardal]

I again, I'm about to receive plastigauge, as some of you advised.
But I have 1 question. The manual states that one should look for an oil clearance of 0.015-0.033mm between bearings and crank. It also states that the maximum oil clearance is 0.1mm. If I get an oil clearance between 0.033 and 0.1mm, what should I do?

I was said that although the manual and EPC have 5 different size bearings, Toyota only sell 3. At stock trim, I should be using 22322 to get the recommended oil clearance. But what if even with all #3 bearings the oil clearance isn't as it is supposed to be?

Best regards