rim and tyre size?
|
02-09-2007, 10:31 PM
Post: #11
|
|||
|
|||
Knudsen Wrote:Are you sure that theres space enough for such wheels? I took a run in my car the other day, and my 15x7 ET 13 with 195 tires, rub if i corners hard through a bumpy roundabout.. And my suspensions isnt soft - well i guess that you, Skassa, would say that it is if they're rubbing in front do you have a way of adjusting in a bit of - camber? if you're not wanting any camber then you'll need to flare out the front fenders. if they're rubbing in back you may want to flare the rear fenders as well or bend back the fender lip that's underneath. you can use a round plumbing pipe: jack the rear up by the chassis and slowly let the car down with the pipe resting on the tire between it and the chasis. make sure the angle the pipe at about a 45/60 degree angle pointing up in the wheel well. do this the full length of the fender from the back of the tire to the front. if you don't feel comfortable doing this then have it done by a body shop. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
rim and tyre size? - Aaron - 02-08-2007, 03:19 PM
[] - dr.occa - 02-09-2007 10:31 PM
[] - oldeskewltoy - 02-10-2007, 02:29 AM
[] - oldeskewltoy - 02-10-2007, 03:10 AM
[] - oldeskewltoy - 02-10-2007, 03:28 AM
[] - peter møller - 02-11-2007, 04:38 AM
[] - SekiguchiUeno - 02-11-2007, 01:12 PM
[] - peter møller - 02-11-2007, 08:30 PM
[] - peter møller - 02-12-2007, 09:38 AM
[] - oldeskewltoy - 02-12-2007, 11:04 PM
[] - peter møller - 02-13-2007, 05:55 AM
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
Tyre load index | Blaze0010 | 6 | 2,063 |
06-12-2025 04:59 PM Last Post: Blaze0010 |
|
Shim size for AM cams | kazi | 4 | 6,230 |
12-18-2017 05:34 PM Last Post: oldeskewltoy |
|
![]() |
Hub size | kazi | 5 | 11,055 |
06-09-2017 10:06 PM Last Post: kazi |
Rim width. Which is best.... | Dino86 | 5 | 7,979 |
01-07-2017 03:09 PM Last Post: Dino86 |
|
Camshaft sprocket bolt size? | harkes | 1 | 5,388 |
07-03-2015 12:41 PM Last Post: Dave W |
User(s) browsing this thread: 2 Guest(s)