Project: My new trackday toy (56k beware!)

[Morten]

So now finally its back to the Hathi fun

Update sofar is this: the ugly rust holes has now magically disapeared.

Engine is also almost ready to go in. A local engine guru has been helpful with a full overhaul. What has been done sofar is:

honing and new piston rings
balancing and weight adjusting of pistons, and rods
balancing of crank, flywheel and pressure plate
ARP rod, main, head and flywheel
TRD 0.8mm headgasket
King rod and main bearings
head porting including valve job
shimless bucket conversion
shimming of block and head for increased compression
the old TRD cams in earlier pic installed (if the measurements add up they are 288in/272ex)
T3 cam gears
OS Giken 3.6kg flywheel
T3 ITB adapter and trumpets

I am inclined to use the blacktop ITB's instead of the more usual silvertop ones, but not 100% decided yet..

Oh, and the plan is to run this by a Megasquirt when everything is ready.

The bonnet and front wings also showed up eventually, and man do I love the weight of that bonnet!