New bits for hachi

[Ian.G]

Yes - I am a parts tart but always have been.

for me maintaining and changing a car to my spec is almost as much fun as the driving. This is a problem I've had will all of my previous cars LOL.

I hope to get rid of the centre console completely at some point so the open shifter with no gators will be nice. I just need to figure out the 'big picture' I dont wanna do too much at once. And who is to say I won't smash the car to pieces on a track at some point soon - you just never know (but I hope not).

T3 is Techno Toy Tuning. They are an american company who fabricate components for especially for hachi. I hear nothing but good words about their products from others on club4ag and here too.

I could have done my cat pipe cheap too by just taking an angle grinder to the existing pipe to get the flanges and just weld up a new pipe - problem is until I know for sure this probe isn't being used I don't want to trash the cat.

Delrin is just a toughened textile that was designed by dupont I think.



Its just a bushing that is more resistent to wear than the standard item. This should just keep the shift slicker for a bit longer - or that is my hope.

I can actually get parts fabricated as one of my friends has his own engineering company (he makes block liners direct for ford - and also has done some work direct for the Audi RS engines too). One off parts are expensive from him because of the quality which is a shame. He made an entire chain tensioner system for my old Hayabusa powered westfield - it was a work of art but cost a packet.