Exhaust fabrication

[Ivan141]

How did you weld it to the stainless steel, what welding process, what metal for the flange?
@ Zax: underdiff is only practical for cars that are lowered a lot, I actually have to worry about ground clearance a lot in this country gone wild with speedbumps. I'ts going to be an over diff exhaust, I'll just have to go through a bit more trouble getting those bends to fit correctly.

If the connecting bit they sell at the carparts store fits correctly I might just go with that. Having a bit of pipe or a flange welded to it is preferable, but it'not very easy to weld stainless steel from what I've heard. The best place to have a flange for the muffler is around the part where the exhaust goes over the diff. That way it's easy to remove and install the whole system.

@wouter: Yeah it would be great if I could borrow it for a couple of days, that way I could start puzzling the correct shape together before even taking the exhaust off the car. Send me a PM with your location etc. and I'll see what we can work out.