|
Crankshaft stamping
|
|
04-24-2024, 05:39 PM
Post: #6
|
|||
|
|||
|
RE: Crankshaft stamping
Ah, that's good to know. The 4AGE manual i have refers to the smallport version with the 42mm crankshaft, so that could make sense.
I hope to never have to change bearing again, but in any case let's just hope that someone will keep producing them 
|
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Crankshaft stamping - Blaze0010 - 04-11-2024, 02:40 PM
RE: Crankshaft stamping - Ivan141 - 04-12-2024, 08:13 AM
RE: Crankshaft stamping - The Doctor - 04-13-2024, 08:44 AM
RE: Crankshaft stamping - Blaze0010 - 04-15-2024, 10:41 AM
RE: Crankshaft stamping - oldeskewltoy - 04-19-2024, 06:41 PM
RE: Crankshaft stamping - Blaze0010 - 04-24-2024 05:39 PM
RE: Crankshaft stamping - Blaze0010 - 06-10-2024, 10:16 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Which new bearings for ae101 4AGZE crankshaft&connecting | ditn | 4 | 7,917 |
10-31-2013 06:04 PM Last Post: ditn |
|
| crankshaft timing belt pulley won't come off | Dino86 | 8 | 10,460 |
02-21-2011 02:05 PM Last Post: Project D |
|
| Crankshaft Pulley Bolt ?? | juantonwan | 3 | 7,141 |
03-05-2010 10:55 PM Last Post: Mikzu IV |
|
| about Crankshaft again | filh | 2 | 5,830 |
12-20-2008 11:53 PM Last Post: filh |
|
| 2a engine crankshaft | c.acton1 | 2 | 4,449 |
09-03-2008 05:37 AM Last Post: F0Bman |
|
User(s) browsing this thread: 1 Guest(s)