Speeduino?

[Ivan141]

Are you going coil-over-plug?
Yes, that is the intention.
Can you use many of the oem sensors?
You can, IAT, MAP, TPS should all be fine as long as you calibrate them properly.
I want ITB's though, have a homebrew quad-MAP sensor board I plan to use for that (allows you to take the strongest vacuum signal per cylinder instead of evening them all out against eachother with a plenum).
Are you doing your own wiring?
Yes, I have been busy rewiring and rewrapping every loom in the car. Adding stuff as needed. My plan is to add a big connector in the engine loom and prepare the additional wiring to that connector so I can just swap the engine looms around later.

And yes, it is Roadworthyish on Youtube indeed.