Wanted: 3-rib engine repair manual

[oldeskewltoy]

As far as the wrist pin.... it says use SST. Typically a 1st gen 4AGE requires a rod heater to properly fit the wrist pin.


As far as 40mm crank info:
Main journal diameter: 47.985mm - 48.000mm(1.8892" - 1.8898")
Rod Journal diameter: 39.985mm - 40.000mm(1.5742" = 1.5748")
Maximum runout: .06mm(.0024")
Maximum taper/out of round: .02mm(.0008")


Main journal clearance: .012mm - .039mm(.0005".0015") Limit .10mm(.0039")
Rod journal clearance: 0.020mm - 0.051mm (.0008" - .0020"). limit .08mm(.0031")
Thrust clearance: .02mm - .22mm(.0008" - .0087") limit .30mm(.0118")