AE86 Driveshaft too long? [SOLVED]

[MyCrazyGarage]

(07-05-2022 09:45 AM)totta Crolla Wrote:  It looks like the axle is positioned correctly but is there a difference between SR5 and AE86 rear link arms?
Could the engine mounts be incorrect? Again, a difference between the two vehicles?
I think you need to measure between the end of the gearbox and the differential drive flange,
compare this to a known quantity (AE86)
If that measurement is correct, suspect the front part of the prop shaft.

I couldnt find a source that states a difference between SR5 and GTS rear link arms.
I think its the rear Driveshaft thats the problem, since the Driveshaft bearing doesent fit properly. (Bearing would need to be moved back)

The previous owner DID modify the engine mounts...to a point where a 30mm washer is required to hold it. I think so he could move the engine forward so the shaft doesent bottom out into the gearbox.
But right now the engine is mounted on its original position.

I will remove the driveshaft later this week and properly measure everything.