DIY: a quick outline on why & how to set pinion angle.

[ditn]

still very confused

you have to measure if gearbox shaft lines up or is parallel to the diff pinion right?
and then also the working(u-joint angle?) angles for both diff pinion and gearbox shaft and middle part.

good pic


all measurements like this?
engine gearbox and front shaft in 1 line
measure diff pinion and it should be parallel
afterwards measure the working angles


at rear i have rose joints for axle and poly rubber on chassis
gearbox mount has a bit stiffer rubbers almost like oem.

Ill try to measure all i can and come back with results next week.