Early EDM non-cat 4A-GE 16v Bluetop Fails emissions (high co)
05-12-2016, 10:14 PM (This post was last modified: 05-12-2016 10:20 PM by Bean.)
Post: #23
RE: Early EDM non-cat 4A-GE 16v Bluetop Fails emissions (high co)
the ECU part is related to the check engine light anyway so not related to the problem but might help.
Not sure where you read 2.4bar in the manual. In mine on page FI68-69 it sais 2.7-3.1 bar with the vacuum hose disconnected and 2.1-2.3bar with it on at idle (which is the important part for emissions).

PS: also check page FI96-97 and see if you get nearly correct readings on your sensors

AE86 ex-daily
Visit this user's website Find all posts by this user


Messages In This Thread
RE: Early EDM non-cat 4A-GE 16v Bluetop Fails emissions (high co) - Bean - 05-12-2016 10:14 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  Blacktop 20V high idle Bravothreezero 0 66 08-08-2026 10:49 AM
Last Post: Bravothreezero
  STL file for the early spec Levin headlight ball joint plastic clip DaLanZhu 2 2,453 04-26-2025 03:24 PM
Last Post: DaLanZhu
  High-beam warning lamp Mylesmck 4 4,142 07-21-2023 07:44 AM
Last Post: banpei
  Engine stress at high speeds gh0st 6 5,741 08-30-2022 07:11 PM
Last Post: Power_uP
  Bluetop Engine Rebuild multiple question Goal 150-160hp Hanzo 16 16,112 04-19-2021 10:08 PM
Last Post: Hanzo

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication