Early EDM non-cat 4A-GE 16v Bluetop Fails emissions (high co)
05-11-2016, 06:36 PM (This post was last modified: 05-11-2016 06:45 PM by totta Crolla.)
Post: #10
RE: Early EDM non-cat 4A-GE 16v Bluetop Fails emissions (high co)
(05-11-2016 05:53 PM)pack Wrote:  
(05-11-2016 04:35 PM)Rascal21 Wrote:  I connected test lamp to W pin on ECU, the other end to Earth, put ECU in diagnostic mode (shorting the two pins in the engine bay diagnostic plug), nothing, not one blink,

Sorry mate... something is wrong.... The light must blink with 2 sec interval repeatedly.

Regards

Yep.
Connect test lamp as before but this time press the throttle more than half way down.
Post result !

Cam timing ok ? Ignition timing ok ?

An analogue brain in a digital World
Find all posts by this user


Messages In This Thread
RE: Early EDM non-cat 4A-GE 16v Bluetop Fails emissions (high co) - totta Crolla - 05-11-2016 06:36 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  STL file for the early spec Levin headlight ball joint plastic clip DaLanZhu 2 532 04-26-2025 03:24 PM
Last Post: DaLanZhu
  High-beam warning lamp Mylesmck 4 2,039 07-21-2023 07:44 AM
Last Post: banpei
  Engine stress at high speeds gh0st 6 3,172 08-30-2022 07:11 PM
Last Post: Power_uP
  Bluetop Engine Rebuild multiple question Goal 150-160hp Hanzo 16 10,983 04-19-2021 10:08 PM
Last Post: Hanzo
  4AGE 16V engine overheat when at high speed chenfon 32 25,183 12-31-2020 06:39 AM
Last Post: chenfon

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication