4age fwd to rwd wiring

[dany.bilan628]

(10-01-2014 05:56 AM)jondee86 Wrote:  Then you have a big and not much fun job ahead !!!

If you install the ECU in the left side kick panel (RHD car) the loom will
not be long enough to reach, and all the wires will need to be extended.
Most likely you will need to de-loom the wiring, identify every plug, and
lay it all out on the floor.

You will also need the third ECU plug that connects to the under-dash
loom. Can't remember exactly why, but I know I had to have that plug
when I did my conversion

Do you still have the car side of the instrument panel loom that connects
to the engine loom via a big square(ish) plug on the firewall above the
back of the engine ?

Cheers... jondee86

I have the LHD ae86. I also have the third plug. I managed to start it (with start fluid) for a second but then it stalls. I have to work on that. On the third plug I gave 12v to 3 wires. my big issue is that as far as I have read, the injector power feed should be yellow wire and I have lots of them