My childhood dream :-)

[xrgeorg]

I need help cuz my head is about to explode....

All this maths about C/R drives me crazy....

So i´m building a 7AGE... not an all out high spec million dollar race machine, just something with bit more torque for daily abuse.

I´ll take a bigport head, Supertech valves, HKS 264° cams, HKS valve springs, adjustable cam gear... nothing special.

Now the interessting point... i still can´t figure out what rods and pistons to use.

I´m sure the stock rods will do the trick but the problem is that the small end is too small to fit 4AGE pistons for higher compression. So i was thinking about modifying them to take 20mm pins...

Now which pistons and headgasket should i use to get a decent c/r that is a compromise between a good amount of horsepower and not blowing the rebuild engine?

Cheers Marco