what bearings for my build?

[Bean]

Hello everyone,

I'd like o get some input/experiences regarding bearings for mains and rods for my engine build.

I'm using a 40mm crank so less options available

So far I considered TRD and ACL Race for the Mains (100$-130$)
and TRD for the rods.

My engine will rev up to 8-9k and 170-200hp @fly.

Thanks for reading and looking forward to your experiences.

PS: also opinions about the 'perfect' clearance/tolerance for the bearings would be interesting. Car is not an all out racer so still used on the street for a run down to the shops etc...