4AGE 20v ITB vacuum instructions on Intecracing.com

[JAVResistance]

Ok lets go step by step.
I had this engine running already but only with a Microtech ECU without turbo, in the pictures below you can see how I had the lines routed, not so neat. Now I'm upgrading to a turbo setup and want to remove whatever that's not needed around the ITB.



Here are some images illustrating what I understood that should be done and what I've done already.



Here on number (1) I connected the Microtech map sensor.



Should this line (2) be blocked of?



I've blocked of this line (3), is this right?



What should be done with line 4? Should the ISCV (5) be removed with turbo setup? What about the VSV? And the throttle opener (6) should also be removed? Can the whole piping below the throttle bodies be removed?

If any of you guys has done a turbo setup, could you share a guide?
Thanks in advance for your help.