Hello there out a rather small country called: Holland (NL)

[CA86]

Yes, the units would help

realised it just after uploading it... *doh*

Actually the method to chart this is rather unsatisfying.

The values needed are determined, are not mathematically founded in any way... Believe me, Ive tried to find someone who could give me more information about it, but sadly no luck

This graph is mainly used to give a estimate about the dynamic behavior of the car...

But as you all know... this is a purely theoretical model

to summarize: the x and y values represent the respective front and rear axle stiffness... the z values is a ratio between them based on load transfer.

In short the stiffness of the axle also determines the stress punt on the tyres.

If there is any way to calculate the (sheer)force/strength/stress absorption capacity of an axle... please let me know!!!

I do know how it's determined...
push-and-pull methods...
Like previously mentioned --> really unsatisfying


PS: I've guessed about the height of the CoG, and put it at 0.5 m