Wiring in spotlights (Cibies)

[jondee86]

That diagram appears to idicate thatyou use two auxiliary relays to
switch the spots. One relay is triggered by the headlight "high beam"
being turned on i.e. you tap 12V off the wire taking 12V to the high
beam of the headlights. This one should turn on the "high beam" of
the spots.

The second relay is triggered by the wire taking 12V to the "side lights"
whatever they may be ?? If, in fact, your spots have a high and a low
beam, then this wire should (presumeably) turn on the low beam of
the spots. However, to make sense, if you want your spots to be on high
when the headlights are on high, and to be on dip when the headlights
are on dip, you should trigger the second relay off the 12V feed to the
dip filament in your headlights

Key thing here is that you need to have wired in two new relays.

Cheers... jondee86